JVC KD-ABT22 Instructions Manual page 313

ENGLISH
ELECTRICAL CONNECTIONS
A
Typical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the aerial cord.
3
Finally connect the wiring harness to the unit.
SUBWOOFER
(see diagram )
Antenna terminal
LINE OUT
(see diagram
White with black stripe White
Left speaker (front)
B
Connecting the external amplifiers and subwoofer
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it
can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker
leads of this unit unused.
Front speakers
JVC Amplifier
JVC
Rear speakers
JVC Amplifier
JVC
* 1 Not supplied for this unit.
* 2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
* 3 Signal cord (not supplied for this unit).
* 4
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
15 A fuse
15 A
To external components (see diagram
Black
)
Yellow * 2
* 2
Rear ground terminal
Red
Blue
Blue with white stripe
Orange with white stripe
Gray with black stripe Gray
Right speaker (front)
/
Remote lead
Remote lead
1
2
3
USB cable (see diagram
USB
)
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe Green
•
•
Y-connector (not supplied for this unit)
Y-
Remote lead (blue with white stripe)
Front speakers
* 1
2
*
* 3
* 4
3
)
12 V
250 mA
200 mA
To car light control switch
Purple with black stripe
Left speaker (rear)
To the remote lead of other equipment or automatic antenna if any
JVC Amplifier
JVC
Ignition switch
Fuse block
Purple
Right speaker (rear)
Remote lead
Subwoofer