Cross Lane; Change Volume Mode - 3M G5 Operating Instructions Manual

Change Volume Mode

3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
•
The headset buttons T1 and T2 communicate only with order point 1
and order point 2, respectively.
•
For paging, pressing the page button on a lane 1 headset is only heard
by other lane 1 headsets. Likewise pressing the page button on a lane 2
headset is only heard by other lane 2 headset.
Notes:
A headset becomes a "lane 1" or "lane 2" headset by momentarily pressing
and releasing the T1 or T2 button.
You can configure the base stations to permit paging to be heard by both
lanes. Refer to configuration section of the manager's guide.

Cross Lane

Cross Lane mode is the preferred mode for lighter volume or whenever one
order taker needs to answer both order points: essentially, the two order points
cross over.
•
Operators will hear signals from both order points: single repeating
beep from order point 1 or a double repeating beep beep from order
point 2.
•
The headset buttons T1 and T2 communicate only with order point 1
and order point 2, respectively.
•
For paging, pressing the page button is heard by all headsets.
If you have night volume reduction in use on your system, the volume change
happens automatically at the set "Day" and "Night" times. However, you can
change the volume mode manually without changing the day or night time
setting.
Perform the following procedure to change between night and day or day and
night volume:
1. Press until the
2. Press .
Enter
3. Use the arrows to select between
4. Press to implement the change or press
Enter
change and leave the previous setting in effect.
selection is highlighted.
Volume
and
DAY NIGHT
November 6 2014 – Revision 2.1
Operation
.
to abandon the
Mode
Page 47 of 77