Table of Contents
Advertisement
5. Locate the battery on the system board.
Battery
6. Remove the battery:
a. Use your finger to press down on one side of the battery; then, slide the
battery out from its socket. The spring mechanism will push the battery out
toward you as you slide it from the socket.
Note: You might need to lift the battery clip slightly with your fingernail to
make it easier to slide the battery.
b. Use your thumb and index finger to pull the battery from under the battery
clip.
Note: After you remove the battery, ensure that the battery clip is touching
the base of the battery socket by pressing gently on the clip.
7. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
8. Close the blade server cover (see "Closing the blade server cover" on
page 40).
Chapter 3. Installing options
37
Advertisement
Table of Contents
