Table of Contents
Advertisement
3. Re-install all hoses, put the caps back on the drains hoses, and put the rest
of the boat together.
Flight Clips
One set (4) of flight clips will hold a maximum of 4
wakeboards.
Do not attempt to overload Flight
Clips with more than one piece of equipment per
slot. When loading boards into flight clips always
insert boards into individual slots so that the board
bottoms are facing each other. Always visually
inspect bungee to insure that the locking ball is
securely in the locking claw (see illustration).
WARNING! Avoid personal injury or property
damage caused by flying objects. Remove any
items from flight clips when trailering boat.
Boarding Platform Removal
Flight Clips
Pull the two pins that are located in the mounting brackets and lift the platform
vertically.
Battery Location
The battery is located under the floor in front of the motor box.
Optional Correct Craft Cruise Operating Instructions
Turn system ON (light blinks slowly, indicating system is armed)
Drive to desired speed, prese ENGAGE and the system takes control of the
throttle (Light stays on steady)
Pull back on the throttle and the system disengages. (Light blinks rapidly,
indicating RESUME function is ready)
Accelerate again and the system resumes control automatically at the last
speed used.
RESUME key feature will recall the last speed used even if the system was
shut off, completely powered down or the DISENGAGE function was used.
To go back to the previous speed, press RESUME and drive to the desired
speed.
Press both keys and the system will DISENGAGE,but remains armed. (Light
blinks slowly) This feature may be used when the operator wishes to go to
manual driving. To return to the last speed used, press the RESUME key and
drive to the desired speed. If the speed is to be changed, drive to that speed
and press engage.
INCREASE / DECREASE key can be pressed when the system is engaged to
change speed in 25 RPM increments to fine tune the speed.
1.17
Hide quick links:
Advertisement
Table of Contents
