Comm Verification; Gps Verification; Inbound Verification; Figure 43: Location Of Status Leds - Cal Amp LMU-26xx Install Manual

CalAmp | LMU-26xx Install Guide
Status LEDs

Figure 43: Location of Status LEDs

5.7.3 COMM VERIFICATION

Installers should first verify that the device has acquired a cellular signal and has registered to the
wireless network before completing installation. If this LED is solid, then the device has registered to the
network and established a data session. Acquiring the wireless network and establishing communication
can take several minutes.

5.7.4 GPS VERIFICATION

Next, verify that the GPS receiver is seeing enough satellites to obtain a valid GPS position. If the green
LED is solid, then the device has found GPS service.

5.7.5 INBOUND VERIFICATION

Lastly, verify is that the device is sending data to the correct server. This is a two-step process and
requires a user to be logged in FleetOutlook. First, force the device to send in an Ignition On event by
turning the ignition key to the forward position. Second, open the breadcrumb detail for the
corresponding vehicle in FleetOutlook. If the device is reporting properly, you should see an Ignition On
event on the Tracking | Breadcrumb Detail tab.

Figure 44: FleetOutlook Reporting Verification

Page 36 MBUD-0199v3.3