Operations; Status Leds - Cal Amp LMU-26xx Install Manual

5.7 VERIFY LMU-26XX OPERATIONS
Installers should verify that the GPS and communications functions of the LMU-26xx are working
properly before departing the installation site. Installation is complete and successful when you have
tested the three sections listed below against the device:

5.2.3 COMM VERIFICATION

5.2.4 GPS VERIFICATION

5.2.5 INBOUND VERIFICATION

5.7.2 STATUS LEDS

The LMU-26xx is equipped with two Status LEDs: one for COMM (wireless network status) and one for
GPS. The LEDs use the following blink patterns to indicate service:
LED #1 (Comm LED - Orange) Definitions
Condition
Modem Off
Comm On - Searching
Network Available
Registered but no Inbound Acknowledgement
Registered and Received Inbound Acknowledgement
LED #2 (GPS LED - Green) Definitions
Condition
GPS Off
GPS On
GPS Time Sync
GPS Fix
MBUD-0199v3.3
CalAmp | LMU-26xx Install Guide
LED 1
Off
Slow Blinking
Fast Blinking
Alternates from Solid to Fast Blink every 1s
Solid
LED 2
Off
Slow Blinking
Fast Blinking
Solid
Page 35