Cal Amp LMU-26xx Install Manual page 20

CalAmp | LMU-26xx Install Guide
5. Route the power cable to the source of 12 Volts continuous and 12 Volts ignition switched.

Refer to Section 5.2: Install Power Connections
power cable.
6. Carefully remove any panels required for access as needed. Ensure there are no sharp edges
that may abrade the wire. Use a suitable means to protect the cable from the sharp edge to
eliminate possible wear or reroute the wire if possible.
7. If applicable, connect Buzzer and/or Switch with LED Cables.

Refer to Section
Optional Switch with LED Cable
8. If applicable, route the I/O Cable to the source of the I/O signals.

Refer to Section 5.5: Connect Optional Inputs
Cable.
9. If applicable, connect the optional serial cables (e.g., NMEA or Garmin).

Refer to Section
serial cables.
10. Follow the steps outlined in
installation.
Page 14
5.3: Optional Buzzer Assembly Cable
instructions.
5.6: Install Optional Serial Cables
Section 5.5: Verify LMU-26xx Operations
for detailed instructions on installing the
instructions and/or
for detailed instructions on installing the I/O
for detailed instructions on install the
to verify successful
Section 5.4:
MBUD-0199v3.3