The connection method must be applied to all installations:
1. Install a ring connector on the Ground wire (Black) as shown below.
2. Select a common grounding point and connect the negative, grounding-wire lead (black lead) to
its ground, the negative battery lead can be used.
The common ground is through the vehicle's chassis and connected using a Ring Terminal, Star
Washer and a ½-inch self-tapping screw or using a provided vehicle ground under the dash.
3. Identify the main harness for the vehicle's key. Use a DVOM (Multimeter) or test light to verify
the constant +12VDC and Ignition sense wires.
Ignition sensor wire refers to a Key controlled power source that has +12VDC in both the Run
and Start positions. Under no circumstance will the "Accessory Position" produce +12VDC on the
Ignition sensor wire.
MBUD-0199v3.3
Figure 12: Ring Connector on Ground Wire
Figure 13: Ground Connection
CalAmp | LMU-26xx Install Guide
Page 17