Figure 14: Main Vehicle Wire Harness; Figure 15: Ignition Wires - Cal Amp LMU-26xx Install Manual

CalAmp | LMU-26xx Install Guide
4. Remove insulation from the correct factory ignition wires using T-Strippers. Use care to remove
only the insulation. Do not damage any of the strands. Using a pick or multi-meter probe,
separate the strands.
5. Wrap the Fuse Holder Lead.

Strip about 1½" to 2"of insulation from the Fuse Holder lead. Feed the exposed fuse holder
lead through the hole in the factory wire. Pinch the factory wire back together and wrap the
fuse lead around source wire at least 3 times.
Page 18

Figure 14: Main Vehicle Wire Harness

Figure 15: Ignition Wires

MBUD-0199v3.3