Figure 32: Aux2 Connection - Cal Amp LMU-26xx Install Manual

CalAmp | LMU-26xx Install Guide
To Install the jPOD Adapter and jPOD Cable via AUX2 Serial Port:
1. Contact Customer Support, select the Installation option (#1), and then request the Over-the-Air
(OTA) LMU-26xx device update before installing the jPOD Adapter and jPOD Cable.
a. It's recommended to use Wiring Harness 5C261 for JPOD installations – see section 3.1.
When the device is installed with the JPOD, the device receives power through the JPOD
connection so the 6ft of power cord as part of harness 5C260 is not needed. 5C261 has
the unnecessary power cable removed.
2. Connect the jPOD Adapter's 5-pin serial to the LMU-26xx AUX2 connector of wiring harness 5C260
or 5C261, see section 3.1 "Available Wiring Harness" (Figure 32).

You can identify the LMU-26xx AUX2 serial port by the white/orange and white/yellow wires pinned
to one of the Molex connectors. Note the AUX1 port will have wire colors matching the jPOD, but
this is coincidental and should be ignored.
Page 28

Figure 32: AUX2 Connection

MBUD-0199v3.3