Pre-Installation Considerations; Plan The Installation; Size And Placement Of Lmu-26 - Cal Amp LMU-26xx Install Manual

4 PRE-INSTALLATION CONSIDERATIONS

The installation of the LMU-26xx and its antennas can have a major impact on device performance. It is
recommended that installers be familiar with the installation of GPS and cellular devices and are
comfortable in a vehicle environment.

4.1 PLAN THE INSTALLATION

Verify Power, Ground and Ignition. Be sure to check each source (power, ground and ignition) to ensure
that the proper signaling exists. This is typically accomplished with a multi-meter.
Before drilling any holes or running any wires, decide where each hardware component will be installed
(LMU-26xx, antennas, peripherals, etc.). Verify that all cables running to the LMU-26xx will not be bent
or constricted. Verify that the LMU-26xx install location is free from direct exposure to the elements
(e.g., sun, heat, rain, moisture etc.).
Be advised that an installation that violates the environmental specifications of the LMU-26xx will void
the warranty.
The best way to ensure a trouble-free installation is to consider your options and make appropriate
decisions before you start. Review the vehicle and determine the best install approach for the LMU-26xx
for the following purposes:

Accurate data gathering and simulation of how customers actually use your solution.

Ongoing monitoring and maintenance of LMU-26xx equipment

Accidental or intentional alteration of the equipment or cable connections.
4.2 SIZE AND PLACEMENT OF LMU-26XX
When planning device installation in a vehicle, take in account the dimensions of the LMU-26xx before
actual installation. Typical installations place the LMU-26xx under the vehicle dashboard, or in the A
Pillar. Verify that you can access to the device, as under some circumstances it may be necessary to add
additional wiring or connections to the LMU-26xx.
Refer to Section 3.3: Environmental Specifications
LMU-26xx.

Verify the LMU-26xx will fit before drilling any holes or running cable.

Ensure that all cables running to the LMU-26xx will not be bent or constricted. Damage to the cables
may impede the LMU-26xx's performance.

Verify that the installation point will not violate any of the LMU-26xx's environmental specification.
Improper installation of the LMU-26xx may void the warranty.
MBUD-0199v3.3
CalAmp | LMU-26xx Install Guide
for the exact measurements and specifications of the
Page 7