Figure 8: Re-Closable Fastener Tape On Lmu-26Xx; Figure 9: Re-Closable Fastener Tape - Prior To Mounting - Cal Amp LMU-26xx Install Manual

1. Under dash mounting may or may not require the use of the re-closable fastener tape. If the
tape is required, follow instructions below:

Clean and prepare the mounting surface and the device before attaching the provided
re-closable fastener tape.

One at a time, remove the backing from two pieces of the re-closable fastener tape.

Firmly press on the sticky-side of the re-closable fastener tape onto the device on both
sides of the device, front or back of device depending on installation requirements
(Figure 7).

Press the other pieces of re-closable fastener tape, bumpy sides together, onto the
device. Do not remove backing (Figure 8).
2. Depending on install location, you may need to attach the wiring harnessed to the device prior
to installation. After the wiring harness is inserted into the device, gently pull on the connector
to ensure the harness is locked in place.
3. Remove the backing from the re-closable fastener tape.
4. Firmly press the device with the re-closable fastener tape onto the mounting surface in the
previously selected and cleaned location, wait several seconds before releasing pressure.
MBUD-0199v3.3

Figure 8: Re-closable Fastener Tape on LMU-26xx

Figure 9: Re-closable Fastener Tape - Prior to Mounting

CalAmp | LMU-26xx Install Guide
Page 13