SMA SUNNY TRIPOWER 6000TL Installation Manual page 30

5 Mounting
1. Ensure that there are no lines laid in the wall which could be damaged when drilling.
2. Mark the position of the drill holes using the wall mounting bracket. Use at least one hole on the
left-hand side and right-hand side in the wall mounting bracket.
3. Drill the holes and insert the wall plugs.
4. Secure the wall mounting bracket horizontally to the wall using screws and washers.
5. If the inverter is to be protected against theft, mark the drill holes:
• Hang the inverter in the wall mounting bracket.
• Mark the drill hole. Use at least one hole on the left-hand side or right-hand side in the bottom
of the enclosure.
• Remove the inverter by lifting it up and out of the
wall mounting bracket.
• Drill the hole and insert the wall plug.
6. Hang the inverter in the wall mounting bracket.
30 STP5-9TL-IA-en-10
SMA Solar Technology AG
Installation Manual