Kyocera KM-1500 Service Manual page 69

Section Jam code
System 00
04
05
Paper feed 10
section
11
12
20
21
22
Fixing sec- 40
tion
Exit sec- 50
tion
DP 70
71
Description
No paper feed
Cover open JAM
Secondary paper feed
timeout
No paper feed from the
MP tray
No paper feed from the
drawer
No paper feed from the
optional drawer
Multiple sheets in the MP
tray
Multiple sheets in the
drawer
Multiple sheets in the op-
tional drawer
Misfeed in the fixing sec-
tion
Misfeed in the exit sec-
tion
No original feed
An original jam in the
original conveying sec-
tion
When the power switch is turned on, the machine detects
activation of the registration sensor or the exit sensor.
A cover open state is detected during copying.
When the machine waits for secondary paper feed, 30 s or
more have elapsed.
The registration sensor does not turn on within 1350 ms of
the MP feed clutch turning on; the clutch is then successively
held off for 1 s and turned back on once, but the sensor
again fails to turn on within 1350 ms.
Registration sensor does not turn on within 1120 ms of the
feed clutch turning on; the clutch is then successively turned
off for 1 s and turned back on once, but the sensor again
fails to turn on within 1120 ms.
Registration sensor does not turn on within 1160 ms of the
feed clutch turning on; the clutch is then successively turned
off for 1 s and turned back on once, but the sensor again
fails to turn on within 1160 ms.
The registration sensor does not turn off within 5055 ms of
the registration clutch turning on (when paper is fed from the
MP tray).
The registration sensor does not turn off within 5055 ms of
the registration clutch turning on (when paper is fed from the
drawer).
The registration sensor does not turn off within 5055 ms of
the registration clutch turning on (when paper is fed from the
optional drawer).
The exit sensor does not turn on within 2765 ms of the regis-
tration clutch turning on.
The exit sensor does not turn off within 2765 ms of the regis-
tration sensor turning off.
When the power switch is turned on, the machine detects
activation of the DP timing switch.
The machine cannot detect activation of the DP timing switch
even after 600 ms elapses since the start of primary paper
feed and cannot detect it at the same timing even after four
times of retry.
The machine cannot detect deactivation of the DP timing
switch even after 4100 ms elapses since the start of second-
ary paper feed.
Conditions
2DC-2
1-5-3