Adjusting The Margins For Printing - Kyocera KM-1500 Service Manual

(3) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-49)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Enter maintenance mode.
Enter "402" using the copy exposure
adjustment keys or zoom +/- keys.
Select the item to be adjusted using
the copy exposure adjustment keys.
Exp. 1 (lit): Printer leading edge margin
Exp. 2 (lit): Printer left/right margins
Exp. 3 (lit): Printer trailing edge margin
Press the program key and the
machine enters the test copy mode.
Yes
Press the stop/clear key to
U404
(P. 1-6-54)
Start
Press the start key.
Press the start key
to output a test pattern.
Are the margins correct?
Yes
Proceed to
another mode?
No
exit maintenance mode.
End
Ejection direction
(reference)
left margin
(2.0
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the zoom (+)
No
key makes the margin wider.
Decreasing the value using the zoom (–)
key makes the margin narrower.
Setting range (initial setting/change in value per step)
Printer leading edge margins: 0 – +10 (3.0/0.5 mm)
Printer left/right margin: 0 – +10 (3.5/0.5 mm)
Printer trailing edge margin: –5 – +10 (3.5/0.5 mm)
Printer leading edge margin
(3 ± 2.5 mm)
Printer
+2.0
mm)
–1.5
Printer trailing edge margin
(3 ± 2.5 mm)
Figure 1-6-53
2DC
Printer
right margin
+2.0
(2.0 mm)
–1.5
1-6-43