Kyocera KM-1500 Service Manual page 66

2DC-2
Off mode time
Sets the amount of time without any operation being
performed until the off mode automatically engages.
1. Select "F24" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: 15/30/45/60/90/120/180/240 (min.)
Selects whether the alarm which sounds when an
error occurs, etc., will be turned on or off.
1. Select "F25" and press the Recall%/Enter key.
2. Select the "on" or "off" and press the Recall%/
Enter key
DP leading edge timing adjustment
Adjusts the location of the copied image if it is shifted
off-center (either forward or backward) when the
optional DP is used to make copies.
1. Select "F26" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: -32 to 32
(Each one-step adjustment is equal to a 0.3 mm
shift.)
Note: This setting item will not be displayed if the
optional DP is not installed.
Paper feed shifting adjustment (drawer)
Adjusts displacement of the copy image.
1. Select "F27" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: -1.0 to +3.0 (1 steps moves 0.1)
" × 11"R size paper.
Use A4R/8 1 /
2
Paper feed shifting adjustment (optional drawer)
Adjusts displacement of the copy image.
1. Select "F28" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: -1.0 to +3.0 (1 steps moves 0.1)
" × 11"R size paper.
1
Use A4R/8 /
2
Note: This setting item will not displayed if the
optional drawer is not installed.
1-4-34
Alarm
Paper feed shifting adjustment (bypass tray)
Adjusts displacement of the copy image.
1. Select "F29" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: -1.0 to +3.0 (1 steps moves 0.1)
" × 11"R size paper.
1
Use A4R/8 /
2
Paper feed shifting adjustment (optional DP)
Adjusts for skewed feeding of originals in the optional
DP.
1. Select "F30" and press the Recall%/Enter key.
2. Select the setting and press the Recall%/Enter
key.
Setting range: -6.6 to +6.6 (1 steps moves 0.1)
Note: This setting item will not displayed if the
optional DP is not installed.
Folio length setting (bypass tray)
Sets the length when folio is selected as the paper
size.
1. Select "F31" and press the Recall%/Enter key.
2. Enter the setting and press the Recall%/Enter key.
Setting is available between 200 and 216 mm.
Toner coverage report
Outputs the report that shows the number of copies
made and average amount of toner used.
1. Select "F31" and press the Recall%/Enter key.
The report is printed out.