Alto-Shaam 767-SK/III Installation Operation & Maintenance page 11

E L E C T R I C A L C O N N E C T I O N
The appliance must be installed by a qualified
service technician. The oven must be properly
grounded in accordance with the National
Electrical Code and applicable local codes.
Plug the unit into a properly grounded receptacle
ONLY, positioning the unit so that the plug is
easily accessible in case of an emergency. Arcing
will occur when connecting or disconnecting the
unit unless all controls are in the "
Proper receptacle or outlet configuration or
permanent wiring for this unit must be installed
by a licensed electrician in accordance with
applicable local electrical codes.
E L E C T R I C A L - 7 6 7 - S K / I I I
VOLTAGE PHASE CYCLE
208-240 ( ) 1 60
AGCY
at 208 1 60
at 240 1 60
230 1 50
E L E C T R I C A L - 1 7 6 7 - S K / I I I
VOLTAGE PHASE CYCLE
208-240 ( ) 1 60
AGCY
at 208 1 60
at 240 1 60
230 1 50
E L E C T R I C A L - 2 8 0 0 - S K / I I I
VOLTAGE PHASE CYCLE
208 1 60
230 1 50
208 3 60
380-415 ( ) 3 50
AGCY
. 10 767-SK/III, 1767-SK/III, 2800-SK/III
PG
I N S T A L L A T I O N
" position.
OFF
/ kW
HZ AMPS
16.0 3.85
15.5 3.21
17.8 4.27
16.0 3.68
220-230V
/ kW
HZ AMPS
32.0 7.70
30.9 6.43
35.6 8.55
34.1 7.86
/ kW
HZ AMPS
43.1 8.96
CORD
37.1 8.54
NO CORD OR PLUG
27 8.96
NO CORD OR PLUG
15.5 9.3
NO CORD OR PLUG
To prevent an electrical shock hazard between
230V:
the appliance and other appliances or metal
parts in close vicinity, an equalization-bonding
stud is provided. An equalization bonding lead
must be connected to this stud and the other
appliances / metal parts to provide sufficient
protection against potential difference.
The terminal is marked with the following
symbol.
NOTE: 230V appliances must be connected to an
electrical circuit that is protected by an
external GFCI outlet.
AWG
NO CORD
OR PLUG
7/7
CEE
PLUG
AWG
NO CORD
OR PLUG
NO CORD
OR PLUG
AWG
,
NO PLUG
/
INSTALLATION OPERATION
D N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
D N G E R
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE.
D N G E R
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70. In Canada, all
electrical connections are to be
made in according with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
/
SERVICE MANUAL