Page 1
Models: 767-S K 1767-S K 1767-SK 767-SK • I N STALLATION • OPERATION • MAI NTENANCE W 1 6 4 N 9 2 2 1 W a t e r S t r e e t • P. O . B o x 4 5 0 • M e n o m o n e e F a l l s , W i s c o n s i n 5 3 0 5 2 - 0 4 5 0...
Page 2
Additional model. Contact the Alto-Shaam service manuals are available from the Alto-Shaam department if you have any questions concerning service department. installation, operation, or maintenance.
Used to notify personnel of N O T E : installation, operation, or maintenance information that is important but not hazard related. Pg. 2. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
USE CAUTION WHEN MOVING OR LEVELING THIS APPLIANCE. S I T E I N S T A L L A T I O N The Alto-Shaam cook CLEARANCE REQUIREMENTS and hold oven must 3-inches (76mm) at the back, 2-inches (51mm) at the top, be installed in a ®...
CAPACITY PER COMPARTMENT 767-SK 196 lb (89 kg) 216 lb (98 kg) 100 lb (45 kg) MAXIMUM 1767-SK 359 lb (163 kg) 399 lb (181 kg) : 53 VOLUME MAXIMUM QUARTS LITERS Pg. 4. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Page 6
Shelf, Stainless Steel, Flat Wire SH-2324 Shelf, Stainless Steel, Rib Rack SH-2743 Side Rack (230V SR-27426 ONLY Stacking Hardware - 767-SK only 5004864 Wood Chips bulk pack ¯Apple 20 lb (9 kg) WC-22543 ¯Cherry 20 lb (9 kg) WC-22541 ¯Hickory 20 lb (9 kg) WC-2829 ¯Maple 20 lb (9 kg)
Re-install the four screws through the flange of the four stacking posts. STACKING POSTS CASTER SET SCREW MOUNTING SCREWS MOUNTING SCREWS Stacking Configurations 767-SK with 767-SK, 750-TH/III, 750-TH-II, 767-SK/III, or 750-S Pg. 6. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
18" (457mm) from the floor. A flexible connector is not supplied by nor is it available from the factory. 767-SK, 1767-SK Pg. 7. INSTALLATION OPERATION SERVICE MANUAL...
Page 9
THE DRIP TRAY CAN OR WILL C AU S E M A J O R E Q U I P M E N T DAMAGE AND WILL RESULT IN A LEAKAGE HAZARD THAT CAN CAUSE PERSONAL INJURY. Pg. 8. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Page 10
E L E C T R I C A L - 1 7 6 7 - S K & VOLTAGE PHASE CYCLE AMPS CORD PLUG 208-240 ( 30.8 NO CORD at 208 30.9 & PLUG at 240 24.4 24.0 NO CORD & PLUG 767-SK, 1767-SK Pg. 9. INSTALLATION OPERATION SERVICE MANUAL...
Page 11
O P E R A T I N G I N S T R U C T I O N S U S E R S A F E T Y I N F O R M A T I O N The Alto-Shaam cook and hold oven is intended U T I O N...
— To set the SMOKING TIMER, turn the smoking POWER SOURCE BEFORE timer knob past the required length of time, then immediately bring it back to the correct CLE NING OR SERVICING. setting. 767-SK, 1767-SK Pg. 11. INSTALLATION OPERATION SERVICE MANUAL...
Page 13
GUIDELINES ONLY LL FOOD HOLDING SHOULD BE B SED ON INTERN L PRODUCT TEMPER TURES LW YS FOLLOW LOC L HEL TH HYGIENE REGUL TIONS FOR LL INTERN L TEMPER TURE REQUIREMENTS Pg. 12. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Always thoroughly rinse surfaces after using a cleaning agent and wipe standing water as quickly as possible after rinsing. 767-SK, 1767-SK Pg. 13. INSTALLATION OPERATION SERVICE MANUAL...
Page 15
POWER SOURCE BEFORE DO NOT USE OVEN IF CONTROLS ARE NOT PROPERLY FUNCTIONING CLE NING OR SERVICING. Refer to the Trouble Shooting Guide located in this manual or call an authorized service technician. Pg. 14. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Page 16
F R O Z E N F O O D S DANGER ZONE ABOVE 32°F (ABOVE 0°C) CRITICAL ZONE 0° TO 32°F (-18° TO 0°C) SAFE ZONE 0°F (-18°C OR BELOW OR BELOW 767-SK, 1767-SK Pg. 15. INSTALLATION OPERATION SERVICE MANUAL...
Page 17
After achieving the desired cycling of the thermostat, the calibration screw must be sealed. Place a few drops of enamel sealant directly on the calibration screw. (Red nail polish or equivalent is acceptable.) Pg. 16. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Replace element. (Temperature O.K.) low wattage. Cannot control temperature but Heating element grounded. Replace element. thermostats check O.K. N G E R DISCONNECT UNIT FROM POWER SOURCE BEFORE CLE NING OR SERVICING. 767-SK, 1767-SK Pg. 17. INSTALLATION OPERATION SERVICE MANUAL...
Page 19
Door Handle 5002726 HD-27080 Shelf, Flat Wire SH-2324 Shelf, Rib Rack SH-2743 Chip Tray 4652 Door Gasket Door Vents GS-22951 Casters Side Rack SR-2303 (2 rigid, 2 swivel w/ brake) SR-27426 (230V) 5008017 Pg. 18. 767-SK, 1767-SK INSTALLATION OPERATION SERVICE MANUAL...
Page 20
SH-2324 Door Handle Shelf, HD-27080 Rib Rack SH-2743 Chip Tray 4652 Drip Pan 14831 Side Rack SR-2303 SR-27426 (230V) Door Gasket Casters Door Vents GS-22951 (2 rigid, 2 swivel w/ brake) 5004862 767-SK, 1767-SK Pg. 19. INSTALLATION OPERATION SERVICE MANUAL...
LI-3027 LI-3027 Temperature Gauge Terminal GU-34197 Block BK-3023 Fan, Box FA-3973 Contactor CN-3487 Terminal Block, Power BK-3019 Cordset CD-3997 767-SK, 125V Unit Shown* *see following page for 230V and 208-240V part numbers 767-SK, 1767-SK Pg. 21. INSTALLATION OPERATION SERVICE MANUAL...
ALTO- SHAAM, INC. RECORD THE MODEL AND SERIAL NUMBER OF THE APPLIANCE FOR EASY REFERENCE. ALWAYS REFER TO BOTH MODEL AND SERIAL NUMBER IN ANY CONTACT WITH ALTO-SHAAM REGARDING THIS APPLIANCE. Model: Date Installed:...
Need help?
Do you have a question about the 767-SK and is the answer not in the manual?
Questions and answers