Replacing The Rollers - Xerox DocuMate 5445 User Manual

Replacing the Rollers

Frequent paper jams are a symptom of a worn roller assembly. A worn roller can cause documents to feed in skewed
at an angle, or multiple pages to feed at the same time. A worn roller should be replaced to avoid damage to the
scanner's internal parts. Before replacing the roller you should clean it as excessive dust on the roller will make it
appear worn and smooth. You cannot properly diagnose a worn roller until you have cleaned it.
Replacement rollers for your scanner can be purchased from the Parts & Accessories page for your scanner at
www.xeroxscanners.com.
When replacing the rollers described in this section, you should replace all of the rollers at the same time. Do not
replace just one roller and not the other. When you are finished replacing the roller, reset the roller count in the user
utility as described on page 214.
Turn off the scanner power and unplug the power cord from the scanner. Press the ADF cover release button and
open the scanner.
When you are done replacing the rollers, close the scanner carefully pressing down on both sides of the cover until it
locks in place. Do not slam down the cover.
Replacing the Feed Roller
® ® 209
Xerox DocuMate 5445 / 5460
User's Guide