Removing & Replacing Oven Door; Removing And Replacing The Lift-Off Oven Door - Frigidaire Gas Range Use & Care Manual

CARE & CLEANING

Removing and replacing the lift-off oven door

CAUTION
To avoid possible injury when removing or replacing the
oven door, follow the instructions below carefully and always
handle the oven door with both hands positioned away from
the door hinge areas.
IMPORTANT
The door is heavy. For safe, temporary storage, lay the door
flat with the inside of the door facing down.
To remove oven door:
1. Open oven door completely (horizontal with floor - Fig. 1).
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven
door (See Fig. 2). A tool such as a small flat-blade
screwdriver may be needed to assist.
3. Close the door to broil stop position. The oven door will
stop into this position just before fully closing.
4. Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle).
5. With the oven door in the broil stop position (Fig. 3), lift the
oven door hinge arms over the roller pin located on each
side of the oven frame (See Fig. 4).
To replace oven door:
1. Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle).
2. Holding the oven door at the same angle as the removal
position (See Fig. 3), seat the hook of the hinge arm over
the roller pins located on each side of the oven door frame
(See Fig. 4). The hook of the hinge arms must be fully
seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - See Fig.
1).
4. Push the door hinge locks up towards and into the oven
frame for both left and right oven door hinges to the locked
position (See Fig. 2).
5. Close the oven door.
Special door care instructions - Most oven doors contain
glass that can break. Please read the following
recommendations:
• DO NOT close the oven door until all the oven racks are fully
positioned inside the oven interior.
• Do not hit door glass with pots, pans, or any other object.
• Scratching, hitting, jarring or stressing the door glass may
weaken its structure causing an increased risk of breakage at
a later time.
34
about
10°
oven
door
hinge
roller
pin
hinge
arm
Oven door hinge
locations
with oven door
fully open.
Fig. 1
Fig. 2
Fig. 3
Fig. 4