External Network Settings; Call Control - TANDBERG 800 User Manual

External network settings

Before using the system together with external network equipment, you must specify the network parameters on
this page.
NOTE T
HE SYSTEM HAS SUPPORT FOR UP TO

Call control

'RS366 Dialing' is the only dialing protocol and would normally be used together with network clocking 'RS449/
V35 Compatible' when the external equipment uses RS366 ports.
'Leased Line' is a non-dialing protocol and should be used when two codecs are connected in a point to point
connection. Use 'Leased Line' when the handshaking signals DTR and CD are available. DTR and CD
correspond to the X21 network's C and I signals.
'Data Triggered' mode uses TxData (transmit data), RxData (receive data) and clock signals only. Use 'Data
Triggered' when no handshake signals are available.
'Manual' should be used when no handshake signals are available, and the external equipment requires a
constantly connected line.
T IP
TIP
O MAKE AN CALL WHEN
TANDBERG Videoconferencing System
384
KBPS USING THE
'L L ' ,
EASED INE IS SELECTED ENTER A NUMBER BEFORE PRESSING
IMPORTANT: T
NOTE
E
CONNECTOR
E N (RS449/V.35/X.21)
XTERNAL ETWORK
CONNECT
71
HE PHYSICAL INTERFACE ON
N
XTERNAL ETWORKS IS ONE NON
. S
PECIAL CABLES ARE REQUIRED
.
INTERFACE
TO ACTIVATE THE DIAL MENU
Advanced use
- 26
STANDARD PIN
.
.