Vnc Settings - TANDBERG 800 User Manual

VNC Settings

Address
The IP-address of the PC with the VNC software installed. To find the IP-address of the PC, select 'Command
Prompt' from the Startup-menu. Type 'ipconfig' and press ENTER.
Display Number
The display number for VNC is 0 and upwards. If you are using WinVNC, double-click on the icon on the toolbar
to view 'WinVNC properties'. This number should correspond with 'Display Number' in this menu.
Password
Enter the same password as specified in WinVNC properties. The password will be shown as asterisk signs (*)
the next time you enter the menu.
Start using VNC
To activate VNC, press 'P
Settings Menu'. See also 'PC SoftPresenter' section for further information.
TANDBERG Videoconferencing System
' on the remote control.Please make sure that 'PC' is set to 'VNC' in the 'Video
C
VNC S S
NOTE
ERVER OFTWARE
• B PC
OTH THE AND THE VIDEOCONFERENCING SYSTEM MUST BE
LAN.
CONNECTED TO THE
• A VNC
SERVER MUST BE INSTALLED ON THE
DOWNLOADED FROM HTTP
• I
NSTALL THE SOFTWARE BY RUNNING THE DOWNLOADED FILE
• T VNC S
O CONFIGURE THE
• S "A S
ELECT CCEPT OCKET
• S "A " "D
ELECT UTO FOR
SYSTEM MUST THEN HAVE THE VALUE
• E
NTER A PASSWORD IN THE
'VNC S '
THE ETTINGS ON YOUR SYSTEM
65
Advanced use
S
ETUP
PC. F
REE SOFTWARE CAN BE
:// . . . . /
WWW UK RESEARCH ATT COM VNC
:
ERVER SOFTWARE
C ".
ONNECTIONS
N ". 'D N
ISPLAY UMBER ISPLAY UMBER
0.
"P "- . M
ASSWORD FIELD UST CORRESPOND WITH
.
.
'
IN THE