External Network Settings; Call Control - TANDBERG 6000 User Manual

External network settings

Before using the system together with external network equipment, you must specify the network parameters on
this page.
T
NOTE
HE SYSTEM HAS SUPPORT FOR UP TO

Call Control

'RS366 Dialing' is the only dialing protocol and would normally be used together with network clocking 'RS449/
V35 Compatible' when the external equipment uses RS366 ports.
'Leased Line' is a non-dialing protocol and should be used when two codecs are connected in a point to point
connection. Use 'Leased Line' when the handshaking signals DTR and CD are available. DTR and CD
correspond to the X21 network's C and I signals.
'Data Triggered' mode uses TxData (transmit data), RxData (receive data) and clock signals only. Use 'Data
Triggered' when no handshake signals are available.
'Manual' should be used when no handshake signals are available and the external equipment requires a
constantly connected line.
TIP T IP
O MAKE AN CALL WHEN
TANDBERG Videoconferencing System
768 /2M
KBPS BPS USING THE
'L L ' ,
EASED INE IS SELECTED ENTER A NUMBER BEFORE PRESSING
NOTE
E N (RS449/V.35/X.21)
XTERNAL ETWORK
C
ONNECT TO ACTIVATE THE DIAL MENU
81
Advanced use
T E
HE PHYSICAL INTERFACE ON XTERNAL
N -
ETWORKS IS ONE NON STANDARD
. S
CONNECTOR PECIAL CABLES ARE
.
REQUIRED
.
INTERFACE
.
26
PIN