External Network Settings; Call Control; Network Clocking; Figure 10 External Setup Page - TANDBERG EDUCATOR2 Installation & Configuration Manual

TANDBERG

External Network Settings

Press External in the CURRENT NETWORK panel of the Terminal Setup page to display the External Network
controls.

Call Control

Buttons Functions
RS366 Dialing Enables RS366 dialing from the system, and is normally used together with network clocking. RS449/V35 compatible
when the external equipment uses RS366 ports.
Leased Line This is a non-dialing protocol and should be used when two Codecs are connected in a point to point connection.
Data Triggered This mode uses TXData, RXData and clock signals only. Use this mode when no handshake signals are available.
Manual This mode should be used when no handshake signals are available, and the external equipment requires a constantly
connected line.

Network Clocking

Buttons Functions
RS449/ V35 Compatible Use when the external equipment provides two clock signals: one for transmit and one for receive.
X.21 Compatible Use when the external equipment provides a common clock signal for both transmit and receive.
Figure 10 External Setup Page
Installation and Configuration Manual - D50103-06
Educator
2
33