Table of Contents
Advertisement
A P P E N D I X F : L I M I T E D W A R R A N T Y
3. A copy of your proof of purchase (purchase receipt).
Repaired products will be returned freight C.O.D. unless sufficient return shipment funds are included
with the unit.
Products sent to the factory from outside the U.S. MUST include return freight funds, and sender is
fully responsible for all customs documents, duties, tariffs, and deposits.
Record the model and serial numbers on the Packaging Materials sheet and retain for your files.
Trace Engineering Co. Inc.
Tel (360) 435-8826
Part Number 3179
5916 195
Street, NE
Fax (360) 435-2229
Effective August 6, 1998
th
Arlington, WA 98223 USA
www.traceengineering.com
Page
81
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Legend and is the answer not in the manual?
Questions and answers
how do you clear error light and alarm from remote control
To clear the error light and alarm on the Trace Engineering Legend remote control, follow these steps:
1. Identify the Error – Check the LED indicators on the remote control to determine the cause of the alarm (e.g., low battery voltage, high temperature, etc.).
2. Resolve the Issue – Address the underlying problem based on the error type:
- If the battery voltage is too low or high, check and adjust the battery condition.
- If there is a high-temperature warning, allow the unit to cool down.
- Ensure all connections (battery and AC output) are secure and clean.
3. Reset the Inverter – Turn the inverter off, wait a few seconds, and turn it back on.
4. Monitor the System – Observe the LED indicators to confirm the error is cleared.
If the issue persists, further troubleshooting may be required.
This answer is automatically generated