Table of Contents
Advertisement
A P P E N D I X D : S P E C I F I C A T I O N S
Factory Default Settings
Search Sense
Auto Low Battery CutOff
Battery Capacity
Battery Type
Charge Rate
VAC dropout
Shorepower Amps
All Specifications Subject to Change Without Notice
Trace Engineering Co. Inc.
5916 195
Street, NE
th
Arlington, WA 98223 USA
Page
76
Defeated
On (11.1 volts DC)
250 amphours
gel cell
100% of maximum
40 VAC
25
Tel (360) 435-8826
Fax (360) 435-2229
www.traceengineering.com
Part Number 3179
Effective August 6, 1998
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Legend and is the answer not in the manual?
Questions and answers
how do you clear error light and alarm from remote control
To clear the error light and alarm on the Trace Engineering Legend remote control, follow these steps:
1. Identify the Error – Check the LED indicators on the remote control to determine the cause of the alarm (e.g., low battery voltage, high temperature, etc.).
2. Resolve the Issue – Address the underlying problem based on the error type:
- If the battery voltage is too low or high, check and adjust the battery condition.
- If there is a high-temperature warning, allow the unit to cool down.
- Ensure all connections (battery and AC output) are secure and clean.
3. Reset the Inverter – Turn the inverter off, wait a few seconds, and turn it back on.
4. Monitor the System – Observe the LED indicators to confirm the error is cleared.
If the issue persists, further troubleshooting may be required.
This answer is automatically generated