Table of Contents
Advertisement
A P P E N D I X F : L I M I T E D W A R R A N T Y
Appendix F: Limited Warranty
Trace Engineering Company warrants its power products against defects in materials and
workmanship for a period of two (2) years from the date of purchase and extends this warranty to all
purchasers or owners of the product during the warranty period.
This warranty period is extended to five (5) years to the original purchaser only, when the following
conditions are met: (a) the unit is installed in a recreational vehicle (RV) only, and (b) the warranty is
registered (warranty card is returned to Trace Engineering) by the original purchaser.
Trace Engineering Company does not warrant its products from any and all defects:
(1) arising out of material or workmanship not provided by Trace Engineering, or
(2) resulting from abnormal use of the product or use in violation of the instructions, or
(3) in products repaired or serviced by other than Trace Engineering repair facilities, or
(4) in components, parts, or products expressly warranted by another manufacturer.
Trace Engineering agrees to supply all parts and labor or repair or replace defects covered by this
warranty with parts or products of original or improved design, at its option, if the defective product is
returned to any Trace Engineering authorized warranty repair facility or to the Trace Engineering
factory in the original packaging, with all transportation costs and full insurance paid by the purchaser
or owner.
ALL REMEDIES AND THE MEASURE OF DAMAGES ARE LIMITED TO THE ABOVE. TRACE
ENGINEERING SHALL IN NO EVENT BE LIABLE FOR CONSEQUENTIAL, INCIDENTAL,
CONTINGENT OR SPECIAL DAMAGES, EVEN IF TRACE ENGINEERING HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES. ANY AND ALL OTHER WARRANTIES
EXPRESSED OR IMPLIED ARISING BY LAW, COURSE OF DEALING, COURSE OF
PERFORMANCE, USAGE OF TRADE, OR OTHERWISE, INCLUDING BUT NOT LIMITED TO
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, ARE LIMITED IN DURATION TO A PERIOD OF FIVE (5) YEARS FROM THE DATE
OF PURCHASE.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS, OR THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGE. SO THE
ABOVE LIMITATIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO
STATE.
Trace Engineering Co. Inc.
5916 195
Street, NE
th
Arlington, WA 98223 USA
Tel (360) 435-8826
Fax (360) 435-2229
www.traceengineering.com
Part Number 3179
Effective August 6, 1998
Page
79
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Legend and is the answer not in the manual?
Questions and answers
how do you clear error light and alarm from remote control
To clear the error light and alarm on the Trace Engineering Legend remote control, follow these steps:
1. Identify the Error – Check the LED indicators on the remote control to determine the cause of the alarm (e.g., low battery voltage, high temperature, etc.).
2. Resolve the Issue – Address the underlying problem based on the error type:
- If the battery voltage is too low or high, check and adjust the battery condition.
- If there is a high-temperature warning, allow the unit to cool down.
- Ensure all connections (battery and AC output) are secure and clean.
3. Reset the Inverter – Turn the inverter off, wait a few seconds, and turn it back on.
4. Monitor the System – Observe the LED indicators to confirm the error is cleared.
If the issue persists, further troubleshooting may be required.
This answer is automatically generated