Table of Contents
Advertisement
TABLE OF FIGURES
Figure 1, Power Output Versus Temperature...................................................................24
Figure 2, Battery to Inverter Cable Connection ..............................................................26
Figure 3, DC Wiring Diagram..........................................................................................30
Figure 4, AC Terminal Block............................................................................................31
Figure 5, AC Wiring Diagram ..........................................................................................32
Figure 6, Typical Mobile Installation Diagram................................................................34
Figure 7, Neutral-to-Ground Switching without external AC source ...............................35
Figure 8, Neutral-to-Ground Switching with External AC ...............................................36
Figure 9, Disabling Neutral-to-Ground Switching ...........................................................37
Figure 10, Three-Stage Charging Profile .........................................................................52
Figure 11, RC6 Remote Control Faceplate Display .........................................................61
Figure 12 , RC7 Remote Control ......................................................................................62
TABLE OF TABLES
Table 1, Minimum Recommended Battery Cable Size (In free air)...................................28
Table 2, Current Carrying Ability of Wire In Free Air at 75°C.......................................29
Table 3, Recommended Minimum AC Wire Sizes .............................................................33
Table 4, Typical Appliance Watts .....................................................................................46
Table 5, Bulk and Float Setpoints .....................................................................................54
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Legend and is the answer not in the manual?
Questions and answers
how do you clear error light and alarm from remote control
To clear the error light and alarm on the Trace Engineering Legend remote control, follow these steps:
1. Identify the Error – Check the LED indicators on the remote control to determine the cause of the alarm (e.g., low battery voltage, high temperature, etc.).
2. Resolve the Issue – Address the underlying problem based on the error type:
- If the battery voltage is too low or high, check and adjust the battery condition.
- If there is a high-temperature warning, allow the unit to cool down.
- Ensure all connections (battery and AC output) are secure and clean.
3. Reset the Inverter – Turn the inverter off, wait a few seconds, and turn it back on.
4. Monitor the System – Observe the LED indicators to confirm the error is cleared.
If the issue persists, further troubleshooting may be required.
This answer is automatically generated