Selcall Indentification Number (Ident); Selcall Ident Labels; The Quiet Mode; Using Selcall - GME TX3345 Instruction Manual

remain quiet to all incoming signals until your selcall number
is called.
your tX3345 will allow you to store up to ten (10) most
frequently called selcall numbers, with each number being
labelled for easy identification.
selCAll iDentiFiCAtion nuMber (iDent)
your radio is factory programmed with its own unique selcall
identification number (ident). this number identifies your radio
from others. your radio's own selcall ident will be displayed
for a few seconds in the lower left of the channel display when
you first turn your radio on. you will need to make this ident
known to others who may need to call you using selcall.
Although your radio is factory-programmed with a
NOTE:
unique selcall ident, you can change your ident to another
number if required (see selcall memories on next page).

selCAll iDent lAbels

When storing selcall idents, you can add labels to each one
to make it easier to identify whose ident you are recalling. in
addition, if an incoming selcall matches one of your stored
idents, the label can be displayed instead of the ident. to add
or display labels, your radio must be in the AlPhA mode. to
switch between AlPhA mode and numeric mode, briefly press
the key followed by the
MENU
F
will be displayed briefly to the lower left of the channel display
to indicate the selected mode.

the quiet MoDe

your radio can be set to monitor signals on a busy channel but
remain quiet unless it receives its own selcall ident. in this way,
you won't be disturbed unless someone calls you. When your
selcall ident is received, the Quiet mode is deactivated and an
alarm sounds to alert you to the call. you can then converse
normally on the channel. to use the Quiet mode, refer to the
Quiet mode section further below. note that activating the
Quiet mode is not mandatory for selcall operation. you can
PA G E 1 4
key. 'AlPhA' or 'numEr'
SQL
ALPHA
still use selcall on any channel whether the Quiet mode is set
or not.
the Quiet mode overrides the normal squelch system to
TIP:
ensure that the radio remains quiet even when the channel is
busy. When Quiet mode is set, you may see the
on the display indicating the channel is being used, however,
nothing will be heard in the speaker unless someone transmits
your selcall ident. Quiet mode can be applied to individual
channels so that some channels remain quiet while others are
open to all incoming signals.
NOTE: the AcmA requires that cumulative selcall
transmissions should not exceed 3 seconds in any 60 second
period. to meet this requirement with your tX3345 you should
not send any more that 3 selcall transmissions per minute.

entering A selCAll iDent

1. Press the CAll button.
sent or received selcall ident. if an AlPhA label is displayed
you will need to press
mode.
2. Press and hold the
hand digit of the selcall ident will flash.
3. Press the
in the flashing digit position.
4. Briefly press the
position.
5. repeat steps 4 and 5 to enter all 5 digits as required. the
selcall number is now ready to send.
6. Press and hold the CAll button. A long beep will be heard
and the radio will transmit the selcall ident.
i n s t r u c t i o n m A n u A l

USING SElCAll

is displayed, along with the last
then SQL to switch to numeric
MENU
ALPHA
F
LVL
key until the radio beeps. the right-
PRI
or keys to select the required number
key again to select the next digit
LVL
PRI
icon appear
t X 3 3 4 5