Scanning In The Quiet Mode - GME TX3345 Instruction Manual

Setting up QuIET mode
to setup the Quiet mode you must first 'tag' the channels that
you want to stay Quiet, then activate the Quiet mode. once the
Quiet mode is activated, the tagged channels will remain quiet
to all incoming signals unless your selcall ident is received.
channels that are not tagged will remain open to all signals
and will operate normally.
To tag individual channels for QuIET operation
1. select the required channel.
2. Press and hold the
QUIET
DUP
appear to the left of the channel number indicating the
selected channel is now tagged for Quiet operation.
To remove the QuIET tag from individual channels:
1. select a channel that has been tagged for Quiet operation.
'Q' will be displayed.
2. Press and hold the QUIET
DUP
disappear indicating this channel is no longer tagged for
Quiet operation.
Activating QuIET mode
1. select a channel that has been tagged for Quiet operation
(you cannot activate the Quiet mode unless a 'tagged'
channel is selected). 'Q' will be displayed on that channel.
QUIET
2. Briefly press the
DUP
the Quiet mode is now activated and all channels that were
tagged for Quiet operation will now be operating in the Quiet
mode.
Deactivating QuIET mode
1. select any channel that has been tagged for Quiet operation.
'Q' and will be displayed on that channel.
QUIET
2. Briefly press the key.
DUP
display and all channels that were tagged for Quiet operation
will now operate normally again.
t X 3 3 4 5
key until the radio beeps. 'Q' will
key until the radio beeps. 'Q' will
key. will appear on the display.
will disappear from the
Receiving signals in QuIET mode
• if a normal signal is received on an open channel (one that is
not tagged with 'Q') the signal will be heard in the usual way.
• if a normal signal is received on a Quiet channel, the
icon will be visible showing that the channel is busy, but no
sound will be heard from the speaker.
• if your selcall ident is received on any channel – open or
Quiet – the Quiet mode will be cancelled and the alarm will
beep to alert you to the call. in addition, the caller's ident or
AlPhA label will be displayed. All channels will now be open
for normal transmission and reception.
if you wish to respond to the caller using selcall, press and
hold the CAll button until the radio beeps. the caller's ident
will be transmitted back to them causing the alarm in their
radio to be activated.
to cancel the alarm on your radio, briefly press the PTT.
to return your radio to the Quiet mode, briefly press the
key. will re-appear on the display.
sCAnning in quiet MoDe
the radio will allow you to scan while the Quiet mode is active.
using this feature you can monitor a group of Quiet channels
or a combination of Quiet and open channels.
To scan in the QuIET mode
1. Briefly press
MENU
group (open or Group scan).
2. store the required channels in the selected scan memory as
described under the scanning section.
3. From those channels, select the ones you wish to remain
Quiet and tag each one for Quiet operation (press and hold
the QUIET key).
DUP
4. select a tagged channel and activate the Quiet mode (briefly
press the
QUIET
DUP
5. to start scanning press the
scanning and the
indicating that the radio is scanning in the Quiet mode.
i n s t r u c t i o n m A n u A l
then SCAN to select the required scan
OS/GS
F
key).
SCAN
key. the radio will begin
OS/GS
and flashing icons will be displayed
QUIET
DUP
PA G E 1 7