Open Scan Mode; Group Scan Mode - GME TX3345 Instruction Manual

OPEN SCAN MOdE

Before scanning, select your preferred working channel using
the or keys. your working channel is the default
channel your radio will transmit on when the Ptt is pressed
while scanning.
Scanning in Open Scan Mode
if a busy channel is found, the scan will pause on the channel
to allow you to hear the signal and will resume scanning once
the channel has been clear for 5 seconds. While the scan is
paused, the icon will continue to animate on the display
to indicate that the scan function is still active.
to talk on your working channel while the radio is scanning,
simply press the PTT. scanning will pause and your radio will
switch to your working channel allowing you to transmit and
receive on that channel. When your conversation has finished
and the channel has been clear for 5 seconds, scanning will
resume.
if the scan pauses on any busy channel and you wish to talk on
that channel, simply wait for a break in the conversation and
press the PTT. the busy channel now becomes your working
channel, replacing your previous working channel. once your
conversation has finished and the channel has been clear for
5 seconds, scanning will resume.
if you need to use your Priority channel while your radio is
scanning (perhaps for an urgent call or an emergency), briefly
press the key followed by the
MENU
F
jump straight to the Priority channel and the scan mode will
be cancelled.
if you wish to remain on a busy channel, briefly press the
key while the scan is paused on that channel. the radio will
exit scan mode and remain on the busy channel.
PA G E 1 2
key. the radio will
LVL
PRI
SCAN
OS/GS
i n s t r u c t i o n m A n u A l

GrOUP SCAN MOdE

Before scanning, store your preferred Priority channel.
Scanning in the group Scan Mode
When scanning, the radio scans all the channels programmed
into the Group scan memory, with the Priority channel being
scanned after every fourth channel.
if a signal appears on the Priority channel – at any time –
the receiver will switch straight to it and will stay there for
as long as the Priority channel is busy. during this time you
can transmit on the Priority channel in the usual way. once
there has been no activity for 5 seconds, the radio will resume
scanning the other channels.
if a signal appears on one of the other channels, scanning will
pause on that channel and will remain there while the channel
is busy, as long as there are no signals on the Priority channel.
during this time the receiver will continue to check the Priority
channel for signals every 2 seconds, resulting in a series of
small 'breaks' in the reception of the paused channel. once
there has been no activity on any channel for 5 seconds, the
radio will resume scanning.
if your radio is paused on a busy channel and you wish to
remain there, briefly press the
scan mode and remain on the busy channel.
NOTE: the radio will no longer be monitoring the Priority
channel (unless it is the same as the busy channel).
to resume scanning, press the
to transmit on the Priority (working) channel At Any timE
while scanning, simply press the PTT key. the radio will switch
straight to the Priority channel. When you have finished your
conversation and there has been no further activity on the
Priority channel for 5 seconds, the radio will resume scanning
the other channels.
to go directly to the Priority channel, briefly press the
key. the radio will exit scan mode.
key. the radio will exit the
SCAN
OS/GS
key again.
SCAN
OS/GS
LVL
PRI
t X 3 3 4 5