Receiving Selcalls; Quiet Mode - GME TX3345 Instruction Manual

To select the AlPHA display mode
Briefly press the key followed by the
MENU
F
or 'numEr' will be displayed for 2 seconds on the lower left of
the display to indicate the selected mode.
TIP:
the normal channel display may give no indication of which
display mode is selected. the selected more will only become
obvious when displaying selcall idents.
Entering and storing a Selcall label
NOTE: you must first store the required ident in memory (as
described above) before you can add an AlPhA label to it.
1. Briefly press the CAll button.
with the last sent or received selcall ident.
2. Press the or
memory in locations 'c0' to 'c9'.
3. Briefly press then
MENU
F
AlPhA will be displayed briefly.
4. if the selected memory's AlPhA label is empty, '- - - - -' will
be displayed, otherwise it will display the last AlPhA label
that was programmed into that memory.
LVL
5. Press and hold the
PRI
left-hand position of the Alpha label will flash.
6. Press the or
in the flashing position then briefly press the
again to select the next position.
The following characters are available:
A B c d E F G h i J K
l m n o P Q r s t u V
0 1 2 3 4 5 6 7 8 9
7. repeat step 6 to enter up to 5 characters as required.
PA G E 1 6
SQL key. 'AlPhA'
ALPHA
will be displayed along
keys to select the required ident
SQL to select the AlPhA mode.
ALPHA
key until the radio beeps. the
keys to select the required character
LVL
PRI
W X y Z
sPAcE * -
8. now press and hold the
will flash for a few seconds then the radio will beep as the
label is stored.
repeat the steps above to add AlPhA labels to other selcall
idents currently stored in memory.
to exit the
wait 10 seconds and the call function will time out). the radio
will return to normal operation.
to display the Alpha labels of incoming selcalls, the radio
should be left in Alpha mode. Any incoming selcall that does
not match those in the memory will display -nEW-. to display
the selcall ident of that caller, briefly press
return to the numeric mode.

reCeiVing selCAlls

When your radio receives its selcall ident, an alarm will sound
to alert you to the call and the
along with the selcall ident or AlPhA label of the caller.
initially the alarm will beep urgently at 2 beeps per second,
then, if the call is not answered, it will slow to around 1 beep
every 3 seconds. it will then continue to beep indefinitely until
you cancel it.
To return the call
Press and hold the CAll button for a few seconds until the
radio beeps. the callers selcall will be sent back to the caller.
To cancel the alarm
key
Briefly press the PTT switch. the alarm will be cancelled and
the channel will be open for normal communication. you can
now talk on the channel in the usual way.

quiet MoDe

the Quiet mode mutes the receiver to prevent incoming
signals from being heard in the speaker until your selcall ident
is received. this allows you to monitor a busy channel for
personal calls without being disturbed by unwanted signals.
once your selcall ident is received, the Quiet mode is cancelled
and all incoming signals are heard in the speaker.
i n s t r u c t i o n m A n u A l
LVL key. the entire Alpha label
PRI
mode, briefly press the CAll button (or simply
symbol will be displayed
then to
SQL
MENU
ALPHA
F
t X 3 3 4 5