Dc Power Connection - GME TX3345 Instruction Manual

Removing the microphone
1. slide the rubber boot back along the microphone cord.
2. squeeze the plastic tab on the microphone plug towards
the plug to unlock it while gently pulling the plug
outwards. if the plug does not come out easily, the tab has
not released correctly and should be squeezed again.
cable

DC Power ConneCtion

the tX3345 is designed for 13.8 volts dc, negative earth
installations only (i.e. where the negative terminal of the
battery is connected to the chassis or frame of the vehicle).
there are two recommended methods of installation.
Radio remains ON when the ignition switch is OFF
connect the radio's negative (black) lead to the vehicle's
chassis, or if preferred, directly to the battery's
negative terminal.
the radio's positive (red) lead should be connected via the 2
amp fuse to the battery's positive terminal. Alternatively, the
positive lead could be connected into the fuse box at a point
that has +13.8 volts continuously available (the battery side of
the ignition switch) via the 2 amp fuse.
t X 3 3 4 5
screwdriver
locking lever
move to left to
release plug
cable entry hole
Radio turns OFF with the ignition switch:
connect the radio's negative (black) lead to the vehicle's
chassis, or if preferred, directly to the battery's
negative terminal.
the radio's positive (red) lead should connect to an accessory
point in the vehicle's fuse box via the 2 amp fuse. this point
should supply +13.8 volts only when the ignition switch is
turned on or in the AccEssory position.
Radio remains ON when ignition switch is OFF
Radio remains ON when ignition switch is OFF
Fuse
RED
Fuse
RED
To Radio
To Radio
BLACK
BLACK
Chassis
Chassis
Radio turns ON and OFF with ignition switch
Radio turns ON and OFF with ignition switch
RED Fuse
RED Fuse
To Radio
To Radio
BLACK
BLACK
Chassis
Chassis
i n s t r u c t i o n m A n u A l
Ingnition Switch
Ingnition Switch
Car battery
Car battery
Ingnition Switch
Ingnition Switch
Car battery
Car battery
PA G E 2 1