Open Scan Mode - GME CP30 Instruction Manual

Open Scan Mode

Open Scan allows any of the channels to be scanned for activity in an ascending
sequence (i.e. from the lowest channel to the highest). If a busy channel is found,
the scan will pause to allow the signal to be heard. Once the channel has been
clear for 5 seconds, the scan will resume automatically.
e.g. Scanning channels 1–8 in Open Scan.
The CP30 has two separate Open Scan memories labelled OPEN1 and OPEN2.
Their operation is identical but each can be independently programmed with a
range of different channels. The OPEN1 scan memory has all 80 channels factory-
programmed. Any channels that are not required can be easily removed. The
OPEN2 scan memory is factory-programmed with all the repeater channels.
Selecting Open Scan
Briefly press MENU
F
OPEN2 is displayed.
Programming Open Scan Channels
ADD or REMOVE your desired channels as described above.
To Start Scanning
Briefly press the
OS/GS
will change rapidly as the channels are scanned. During this time the display will
show OS-xx where OS indicates Open Scan and xx indicates your working channel
(your last-selected channel). The radio will return to this channel when you stop
the scan.
To Stop Scanning
Briefly press the
OS/GS
return to your working channel.
40
then SCAN to cycle through the scan groups until OPEN1 or
OS/GS
SCAN
key. The
SCAN
key. The
Open Scan
icon will animate and the channel numbers
icon animation will stop and the radio will
Scanned Channel
Last Selected Channel
(Working Channel)
Scan Icon
CP30 INSTRUCTION MANUAL