Table of Contents
Advertisement
OPEN SCAN
Open Scan allows a group of channels to be scanned in an ascending sequence.
If a signal is found, the scan will pause on that channel. During this time you can
press the PTT on the microphone and talk on the channel. Once the channel has
been clear for 5 seconds the scan will resume.
SELECTING OPEN SCAN
To select open scan:
1.
Press the MENU key.
2.
Navigate to select SCAN SETTINGS.
The default working channel is in the Open Scan mode.
In the Open Scan mode, your default working channel is the channel your radio
switches to when you press the PTT while scanning. To set your working channel
simply select the required channel before you press SCAN. e.g. to make channel 24
your working channel, simply select channel 24 before pressing SCAN.
To begin scanning:
Briefly press SCAN. A high beep will be heard, 'SCANNING' will be displayed and
the
icon will animate. During this time the scan mode and the number of
channels being scanned will be displayed along with the selected Zone.
If there are less than 2 channels programmed into the scan memory when you
press SCAN, a low beep will be heard and the command will be ignored.
XRS-330C
23
Advertisement
Table of Contents
