Longitudinal Motion Of The Fabric Support Plate - DURKOPP ADLER 580 Operating Instructions Manual

7.

Longitudinal motion of the fabric support plate

3
1
2 1
Caution: Danger of injury!
Exercise utmost caution when making adjustments with the machine
running.
Note
Please observe the necessary program setting as described in
chapter 1.1.
Standard checking
When the machine is in reference position, the distance between the
edge 3 of the fabric support plate 2 and the front edge 1 of the throat
plate support should amount to approx. 113 mm.
The distance between reference switch and switch sheet must not
exceed 0.5 mm.
–
Switch the machine on.
–
Press key "F" at the control panel.
–
Enter code "2548".
–
Press key "OK".
The control switches to the technician level.
–
Select menu "Test functions".
–
Press key "OK".
–
Select menu "Sewing proc.".
–
Press key "OK".
–
Select menu "Start ref.".
–
Press key "OK"
The machine runs to its initial position.
–
Switch the machine off.
–
Check the distance between edge 3 of the fabric support plate and
front edge 1 of the throat plate support.
1
3
19