2.3
Thread take-up disc
6
5
4
8
2
1
Caution: Danger of injury!
Turn the main switch off.
Adjust the thread take-up disc only with the machine
switched off.
Standard checking
When the arm shaft has been locked with the locking pin 2
in such a way that the looper turret is in its left end position (left stitch),
the rotary thread take-up disc 6 should be positioned so that
a drill 4 (2 mm diameter) pushed through the drill-hole of the thread
take-up disc rests on the right surface 3.
Correction
–
Unscrew the tension plate 1.
–
Loosen the screws at the (timing) gear 5.
–
Insert the drill 4 through the drill-hole in the thread take-up disc 6.
–
Turn the thread take-up disc until the drill 4 abuts on the surface 3.
3
–
Tighten the screws at the (timing) gear 5.