Setting Fabric Sliding Plate And Vacuum Plate - DURKOPP ADLER 745-35-10 S Service Instructions Manual

Setting fabric sliding plate and vacuum plate

11 Setting fabric sliding plate and vacuum plate
Fig. 115: Setting fabric sliding plate and vacuum plate
(1) - Threaded pin
Proper setting
The vacuum plate is in the same plane as the tabletop.
To set fabric sliding plate and vacuum plate:
1. Swivel the fabric sliding plate aside.
2. Check the height of the vacuum plate in relation to the tabletop.
3. Turn the threaded pin (1).
4. Readjust the supporting screws (2).
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
WARNING
Risk of injury from moving parts!
Crushing possible.
Set fabric sliding plate and vacuum plate only when
the sewing unit is switched off.
• Set vacuum plate higher: turn clockwise
• Set vacuum plate lower: turn counterclockwise
①
②
(2) - Supporting screws
133