Trophy 20
Replacing the tiller PCB
Preparation
• Switch off the scooter with the ignition key.
Instructions
The following operations are required to replace the tiller
PCB:
Note! Suitable work area required!
• Remove the basket and the mounting bracket for the
mirrors.
• Remove the knob of the speed potentiometer, the two
bolts and remove the front tiller cover.
• Remove the nut, the four Ejot screws and the
dashboard.
• Disconnect all connectors from the tiller PCB.
• Remove the three Ejot screws to remove the tiller PCB.
• Mount the new tiller PCB.
• Rebuild the scooter in the reverse order.
1
3
Relevant article numbers
• 9004185 Steering wheel
Tools used
• Socket, 10 mm
• Screwdriver, crosshead
Notice
• Make sure the scooter is switched off.
2
4
Service instructions | 61
Service instructions | 61