Mount The Crutch Holder, Chassis - Handicare TROPHY 20 Service Manual

Trophy 20

Mount the crutch holder, chassis

Preparation
• Switch off the scooter with the ignition key.
Instructions
The following operations are required to mount the crutch
holder on the chassis:
Note! Suitable work area required!
• Remove the rear cover.
• Remove the two hexagon bolts and washers to remove
the rear bumper.
• Mount the crutch holder bracket on the rear frame side
of the electronics compartment.
• Drill two holes in the rear bumper (drill location is
indicated on the inside).
• Replace the rear bumper and mount the crutch holder
via the bumper on the bracket.
1
3
7
Relevant article numbers
• 1012515 Crutch holder mounted to chassis
Tools used
• Torque wrench, socket, 7 mm
• Metal drill, 4 mm
• Drill
2
7
110948-03-013
4
110948-03-015
Service instructions | 71 Service instructions | 71
1
Ø4
1
1
110948-03-014
110948-03-015A