Trophy 20
5.4.6
Electronics
Replacing the controller
Preparation
• Switch off the scooter with the ignition key.
Instructions
The following operations are required to replace the
controller:
Note! Suitable work area required!
• Remove the rear cover.
• Disconnect all connectors from the power module.
• Remove the two hexagon head cap screws and remove
the controller.
• Mount the new controller.
• Rebuild the scooter in the reverse order.
1
3
Relevant article numbers
• 9002457 S-drive controller 120A
• 9004513 S-drive controller 90A
Tools used
• Allen key, 5 mm
Notice
• N.a.
2
4
Service instructions | 65
Service instructions | 65