Bunn ULTRA Technical Training Manual page 10

INSTRUCTIONS (Continued)
18. Reinstall front panel, left panel and both
motor covers.
21. Install hoppers onto machine and
slide probes onto hoppers into slots
provided.
24. Install customer supplied pump system.
Turn on pump system and water sup -
ply. Check all tubing connections for
leaks.
10
Ultra Training Manual
19. Assemble a .25" quick disconnect t -
ting, 1.25" neoprene tube and barbed
elbow as shown with the .50" barb
pointing down.
22. Route the tubes from the solenoids up
to the quick disconnect ttings on the
hoppers. The tubes are supplied with
extra length to allow for trimming if
desired. Slip a clamp over the end of
the tube and install a .25" male discon -
nect tting. Position the clamp over the
barb area of the tting and crimp into
place.
NOTE: Make certain the tubes are routed
to the correct hoppers to prevent product
from being mixed or hoppers over owing.
25. Install snap clamps on to hoses just
above the bushings to prevent hoses
from being pulled loose from the so -
lenoid valves.
(continued)
3
20. Remove one or both plugs from the hop -
per depending on whether a separate
water line is being installed. Install the
quick disconnect tting into the hole on
the hopper and secure with nut provided
with tting.
23. Connect the tubes to the hoppers.
37570 072706