Download Print this page
Bunn ULTRA-2 PAF Use And Care Instructions

Bunn ULTRA-2 PAF Use And Care Instructions

Ultra-2 cold drink dispenser with paf dispenser

Advertisement

USE & CARE INSTRUCTIONS for ULTRA-2 COLD DRINK DISPENSER WITH PAF DISPENSER
NOTICE - This guide is for quick reference only and is not intended to replace the information in the Operation Manual!
DISASSEMBLY & CLEANING
EMPTY ALL PRODUCT FROM THE ULTRA HOPPERS INTO A BUCKET OR CONTAINER BEFORE PROCEEDING!
1. Open the Cabinet Door and
allow the support arms to lock
in place. Door must remain
open during the entire cleaning
procedure.
5. Pull the Frother off the Motor
Shaft. Notice the flat keyway on
the shaft and the matching key-
way inside the Frother. It is im-
portant that these two keyways
are lined up when reassembling.
43553.0000A 07/10 ©2010 Bunn-O-Matic Corporation
2. Place the power switch in
the OFF position. Slide the gate
shut on the powder hopper and
remove the hopper. Wipe the
hopper tray clean of powder
residue.
6. Twist Whipper Chamber Re-
ceptacle clockwise and pull it off
the Motor Shaft. Wipe down all
inside surfaces.
(Page 1 of 4, Continued)
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601
ULTRA-2 PAF
ULTRA-2 PAFA
3. Pull the Mixing Chamber out
of the Whipper Chamber.
7. Slip the O-ring off the Whip-
per Chamber Receptacle and
remove the shaft seal.
FAX: (217) 529-6644
4. Twist the Whipper Chamber
clockwise and pull it off the
Whipper Chamber Receptacle.
8. Wash components in a mild
solution of dish detergent using
a bristle brush. Rinse and dry
each item thoroughly before
reassembling.
NOTE: Parts must be thoroughly
dry before adding powder to the
hopper.

Advertisement

loading

Summary of Contents for Bunn ULTRA-2 PAF

  • Page 1 BUNN-O-MATIC CORPORATION PHONE: (217) 529-6601 43553.0000A 07/10 ©2010 Bunn-O-Matic Corporation ULTRA-2 PAFA 3. Pull the Mixing Chamber out of the Whipper Chamber. 7. Slip the O-ring off the Whip- per Chamber Receptacle and remove the shaft seal.
  • Page 2 DISASSEMBLY & CLEANING Turn cooling to OFF selection. Empty all product from the hopper(s). Turn auger to OFF selection. 2. Depress the hopper lock 1. Slide PAF assembly back plunger, lift slightly. until it latches before removing ULTRA Hoppers. 5. Remove the hopper seal from 6.
  • Page 3 ASSEMBLY 1. Replace the auger nose bush- 2. Install the hopper seal over the ing inside the front of the hopper. flange at the rear of the cooling drum as shown. 5. Position the faucet seal and 6. Slide the faucet valve assem- the return spring in the faucet bly into place on the hopper.
  • Page 4 THOROUGH CLEANING OF THE PAF HOPPER (Once a week) 1. Open the Cabinet Door and 2. Slide the gate shut on the allow the support arms to lock powder hopper and remove the in place. hopper. Remove the Cover and empty the contents.

This manual is also suitable for:

Ultra-2 pafa