Bunn ULTRA Technical Training Manual page 9

INSTRUCTIONS (Continued)
9. Reinstall the main board into the
machine using the original mounting
screws.
12. Plug wire harness (supplied with kit)
into Auto Fill board connector and route
wires back into the machine.
15. Connect the wires to the ll valves both
water and product as needed according
to the wiring schematic provided. Red
and White wires to the right valve(s),
Blue and white wires to the left valve(s).
Please note that Left and Right are from
the front of the machine, Users left and
right.
10. Remove hole covers from the base of
the machine as needed to route water
and product tubing through base.
13. Remove top nut o of grounding stud
in the base of the machine, add on the
green grounding wire from the new har
ness and reinstall the nut onto the stud.
Make sure that all the other grounding
wires remain on the ground stud.
16. Route Pink and Tan wires up to level
probes and attach using nuts provided.
Pink is the right probe and Tan is the
left probe.
2
11. Install provided bushings into product/
water holes to protect the tubing.
14. Install valve and bracket assembly by
feeding the attached tubing through
- the smaller snap bushings in the base
of the machine.
17. Position the valve and bracket assembly
between the right front corner post and
the right side fan shroud and secure
with screws provided.
Bunn-O-Matic Corporation
37570 072706
9