Kemppi FastMig KM300 Operating Manual page 6

spatter and fire safety
• Welding is always classified as hot work, so pay attention to fire safety regulations during
welding and after it.
• Remember that fire can break out from sparks even several hours after the welding work
is completed.
• Protect the environment from welding splatter. Remove flammable materials, such as
flammable fluids, from the welding vicinity and supply the welding site with adequate fire
fighting equipment.
• In special welding jobs, be prepared for hazards such as fire or explosion when welding
container type work pieces.
• Never direct the spark spray or cutting spray of a grinder toward the welding machine or
flammable materials.
• Beware of hot objects or spatter falling on the machine when working above the machine.
• Welding in flammable or explosive sites is absolutely forbidden.
general electric safety
• Only connect the welding machine to an earthed electric network.
• Note the recommended mains fuse size.
• Do not take the welding machine inside a container, vehicle or similar work piece.
• Do not place the welding machine on a wet surface and do not work on a wet surface.
• Do not allow the mains cable to be directly exposed to water.
• Ensure cables or welding torches are not squashed by heavy objects and that they are not
exposed to sharp edges or a hot work piece.
• Make sure that faulty and damaged welding torches are changed immediately as they can
be lethal and may cause electrocution or fire.
• Remember that the cable, plugs and other electric devices may be installed or replaced
only by an electrical contractor or engineer authorised to perform such operations.
• Turn off the welding machine when it is not in use.
Welding power circuit
• Insulate yourself from the welding circuit by using dry and undamaged protective
clothing.
• Never touch the work piece and welding rod, welding wire, welding electrode or contact
tip at the same time.
• Do not put the welding torch or ground cable on the welding machine or other electric
FI
equipment.
Welding fumes
SV
• Ensure proper ventilation and avoid inhaling the fumes.
• Ensure sufficient supply of fresh air, particularly in closed spaces. You can also ensure the
NO
supply of clean and sufficient breathing air by using a fresh-air mask.
• Take extra precautions when working on metals or surface-treated materials containing
DA
lead, cadmium, zinc, mercury or beryllium.
transportation, lifting and suspension
EN EN
• Never pull or lift the machine by the welding torch or other cables. Always use the lift
points or handles designed for that purpose.
DE
• Only use a transportation platform designed for the equipment.
• Try to transport the machine in an upright position, if possible.
• Never lift a gas cylinder and the welding machine at the same time. There are separate
NL
provisions for gas cylinder transportation.
• Never use a welding machine when suspended unless the suspension device has been
FR
designed and approved for that particular purpose.
• Do not exceed the maximum allowed load of suspension booms or the transportation
ES
trolley of welding equipment.
• It is recommended that the wire coil be removed during lifting or transportation.
PL
environment
• The welding power source is not suitable for use in rain or snow, although it can be used
RU
and stored outdoors. Protect the equipment against rain and strong sunlight.
• Always store the machine in a dry and clean space.
4