2. Quick Start – Basic Setup
If a 2-frame delay or more is acceptable for your application, the 3D Stereo
Sync Cable may not be needed. Instead, connect your video source's stereo
3D sync output directly to your emitter or Z-screen PZE device.
Note: This basic setup is recommended only for 2 or more frame delay immersive
systems. For alternative setups, see 4.1.
Figure 1. Quick start configuration, no cable, CRT
This quick start configuration requires the following Simulation 3D submenu
adjustments:
•
Set 3D Stereo Sync Locking to Off.
•
Adjust Dark Interval to overcome the shutter speed difference
between the projector and the LCD glasses.
•
Adjust Frame Delay if the L/R frames are inverted.
Christie Digital Systems Inc. Using 3D in Mirage
5