Reassembly - Hitachi C-10FCB Technical Data And Service Manualice Manual

D. Vise ass'y
Tool required:
• Phillips screwdriver
1. Remove the Wing Bolt M6 x 15 [19] to remove the Vise Shaft [24].
2. Remove the Machine Screw M4 x 10 [23] to remove the Vise Plate [22].
3. Remove the Knob Bolt M10 x 66 [18] from the Screw Holder [20].

11-2. Reassembly

Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(1) Prior to reassembly, measure the insulation resistance of the armature, stator, switch and other electrical
components and confirm that the insulation resistance of each part is more than 5 MΩ.
(2) When replacing the Spring [5], apply 5 grams of Hitachi Motor Grease No. 29 (Code No. 930035) to the inner
circumference of the new Spring [5] prior to reassembly.
(3) When replacing the Liner [44], apply 8 grams of Hitachi Motor Grease No. 29 (Code No. 930035) to the sliding
surface of the Base [49] prior to reassembly.
--- 17 ---
Fig. 18