Hitachi C-10FCB Technical Data And Service Manualice Manual page 18

C. Armature ass'y
Cord, stator ass'y and housing ass'y
Tools required:
• Phillips screwdriver
• Flat-blade screwdriver
• Plastic hammer
1. Remove the Brush Cap [64] and the Carbon Brush [63].
2. Remove the four Machine Screws (W/Washers) M5 x 45 (Black). Then the Housing Ass'y can be removed
together with the Handle Cover [70] from the Gear Case [85]. Then the Armature Ass'y [71] and the Lock
Lever [76] can be removed.
3. Remove the screws from the Gear Case [85].
4. Remove the four Tapping Screws (W/Flange) D4 x 20 (Black) [83] to remove the Handle Cover [70].
5. Remove the internal wires from the Switch [80]. Remove two Tapping Screws (W/Flange) D4 x 20 (Black) to
remove the Cord [54], Cord Armor D10.7 [55] and Cord Clip [65].
6. Remove two Tapping Screws (W/SP. Washer) D5 x 65 to remove the Brush Terminal [68] from the Brush
Holder [62]. Gently tap the surface of the Housing Ass'y [60] where the Gear Case [85] was mounted with a
plastic hammer to remove the Stator Ass'y [67].
Fig. 17
--- 16 ---