Hitachi C-10FCB Technical Data And Service Manualice Manual page 15

1. Remove the four Bolts (W/Washers) M8 x 35 (Black) and remove Fence (A) [46] and Fence (B) [31].
2. Loosen the Clamp Lever [2] and remove the Machine Screw (W/Washers) M6 x 12 (Black) [1]. Turn the Bolt
(Left Hand) M10 x 40 [3] and remove it from the Hinge [7].
3. Remove the Hex. Socket Set Screw M6 x 10 [10]. Tap the end surface of Shaft (C) [8] from the front of the
Turn Table [38] using a flat-blade screwdriver and a hammer to remove it.
4. Remove the Nylon Nut M8 [32] and remove the Turn Table [38] from the Base [49].
5. Remove the Spacer [42] and the Table Insert [39] from the Turn Table [38] by removing each mounting screw.
--- 13 ---