Adjustment Of Components; Bevel Angle Adjustment; Packing - Hitachi C-10FCB Technical Data And Service Manualice Manual

9. ADJUSTMENT OF COMPONENTS

9-1. Bevel Angle Adjustment

Before the power tool is shipped from the factory, it is adjusted for 0˚ and left 45˚ bevel cutting angles.
The positioning and bevel cutting angle can be adjusted by changing the height of the 8 mm bolt (maximum bevel
cutting angle is 45˚).

10. PACKING

(1) Preparation before packing
Remove the side handle, holder and dust bag from the main body. Then turn the turn table 60˚ clockwise.
(2) Mounting packings (B) and (C)
Place packing (C) under the gear case and swing the motor section. Pressing on packing (C), hook the
stopper pin on the gear case. Put the housing through the hole of packing (B).
(3) Mounting packing (A) and upper packing
Put the main body mounted with packings (B) and (C) in the carton box aligning with the base packing.
Put packing (A) at the left of the base. Place the upper packing on the main body. Close the lid of the carton
box and secure it.
Stopper pin
Packing (C)
8 mm bolt
Fig. 11
Packing (B)
Fig. 13
8 mm bolt
Packing (A)
Base packing
--- 11 ---
Fig. 12
Upper packing
Carton box
Fig. 14